20
Basics
Powering the unit on
Connect the supplied AC adaptor to the USB port
6
using the cable supplied and plug the
adaptor into the AC mains. This will ensure that the internal battery becomes fully charged.
Connect the main outputs to a monitoring system (powered speakers or a separate amplifier and
passive monitors); alternatively plug in a pair of headphones if you prefer.
Long-press the POWER button
8
, and the grid will show the boot-up display for approximately
two seconds:
After initial boot-up, the display will change colour from pale red to bright green sequentially from
top left to bottom right, indicating Pack loading.
To Next Page
Loading...