66
Mixer
Circuit Rhythm includes an eight-channel mixer to let you adjust the volume of each track relative
to the others. By default, all the tracks play at a volume level of 100 (arbitrary units, range 0-127),
leaving you with the Master Volume control
4
to adjust the output level as required.
Press Mixer
11
to open
Mixer View:
1 87652 3 4
Scene pads
J
ProjectsSaveDuplicateClear
J
1-16
17-32
Tempo
Swing
Tap Click Mutate Packs
8 Resonance
MUTE
TRACK 1
MUTE
TRACK 2
MUTE
TRACK 3
MUTE
TRACK 4
MUTE
TRACK 5
MUTE
TRACK 6
MUTE
TRACK 7
MUTE
TRACK 8
(Pulsing
bright/dim)
1 Tune
2 Start
3 Length
4 Slope
5 Distortion
6 HP Filter
7 LP Filter
Setup
The illuminated pads on Row 1 are Mute buttons for each track. Press a pad to stop the sequencer
triggering a track’s samples and CC automation; this will in turn mute the track. Press again to unmute.
The pad’s illumination dims to indicate a Mute state.
Track level
By default, in Mixer View the Macros control volume level of each track. This is indicated by the J button
15
being lit. Macro LEDs light in the corresponding track colour, and dim as the track level is reduced.
Track level adjustment with the Macros may be automated. If Circuit Rhythm is in Record Mode,
changes to the individual track levels will be recorded to the Pattern. To delete Volume Level
automation, hold Clear
17
and turn the Macro control. The Macro LED will light red to indicate that
the deletion has been completed.
To Next Page
Loading...