69
Reverb
To add reverb to one or more tracks, select a reverb preset. The pad corresponding to the active
preset illuminates brightly. The Macros are now the reverb send level controls for the eight tracks:
this is exactly the same arrangement as used in Mixer View. The Macro LEDs are now dimly lit cream;
as you increase a send level you will hear reverb being added to the track it controls and the LED will
increase in brightness.
You can add the selected reverb effect to any or all tracks to different degrees by using the other
Macro controls. It is not possible to use different reverb presets on different tracks, however.
Details of the eight reverb presets are given below:
PRESET DELAY TYPE
1 Small Chamber
2 Small Room 1
3 Small Room 2
4 Large Room
5 Hall
6 Large Hall
7 Hall – long reflection
8 Large Hall – long reflection
Delay
Adding delay is the same process as reverb: to add delay to your tracks, select an effect from the
pads on Rows 1 and 2. The Macros are now per-track delay send level controls; you’ll see that their
LEDs are now showing peach to confirm their reassignment to the delay FX.
Although the same Macros are used as reverb send levels and delay send levels, the two effects
remain independent: the Macros adopt one function or the other according to whether the last FX
pad pressed was a reverb preset or a delay preset.
To Next Page
Loading...