85
Using microSD Cards
WARNING:
Do not remove the microSD card from Circuit Rhythm during Save or Load operations. Doing so
may result in the loss of previously saved work. Note that Save operations include the process
of duplicating a pack, transferring content from Components, and saving newly recorded and
trimmed samples.
A microSD card inserted into the rear panel card slot allows access to multiple Packs. Circuit Rhythm’s
internal memory holds only a single Pack: the microSD card can hold a further 31 Packs, thus allowing
the availability of up to 32 Packs for loading to Circuit Rhythm while the card is inserted.
If a microSD card has not been inserted since powering up, Packs View will display a red and yellow icon
that means “no SD available”:
The “no SD” icon is also displayed in other situations, see ‘Removing a MicroSD card’ below for more
details. Circuit Rhythm is fully operational without a MicroSD card, but you will only have access to the
internal Pack. If a microSD card is present, Packs View will display the available Packs and allow you to
load a new Pack as described in ‘Loading a Pack’ above.
If the unit is powered on with no microSD card present (resulting in the internal Pack being loaded),
one can be inserted at any point to gain access to the card’s content. If the card has previously
been removed, reinserting it will allow access to the card’s content again, and normal operation will
continue if removing the card previously had disrupted any functionality.
To Next Page
Loading...