24
There’s nothing special about the slots containing factory demo Projects: you can overwrite these if
you wish: you can always re-load them by using Novation Components.
You don’t need to be in Projects View to save a Project you’ve been working on. If you press Save
19
, the
button flashes white; if you press it a second time, it briefly flashes green rapidly to confirm the save
process. However, in this case, your work will be saved in the last selected Project memory, which will
most likely be the one that held an earlier version; the earlier version will be overwritten.
To save your work in a different Project memory (leaving the original version unchanged), enter
Projects View. Press Save; both Save and the pad for the currently selected Project will flash white.
Press a different memory pad: all the other pads will go dark, and the selected pad will flash green
rapidly for a second or so to confirm the save process.
To make identifying Projects easier, you can assign one of 14 colours to any of the pads in Projects
View. See “Changing Project Colours” on page 97.
To Next Page
Loading...