Page 2 looks like so:
The higher parameter is “Reverb decay”. In this case with a value of 080.
This parameter adjusts the rate at which the Reverb effect decays away.. Use the higher Data knob to adjust this parameter. The
range of this parameter is 000 to 127. This parameter is memorised with a Program in Program Mode or memorised with a
Program or Performance in Performance Mode depending on the value of the Part’s “Part FX” parameter.
The lower parameter is “HF damp”. In this case with a value of 020
This parameter determines the rate at which High Frequencies decay away in the Reverb & is called High Frequency Damping.
Use the lower Data knob to adjust this parameter. The range of this parameter is 000 to 127. This parameter is memorised with a
Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the
Part’s “Part FX” parameter.
Page 3 looks like so:
The higher parameter is “Reverb wheel”. In this case with a value of +50
This parameter determines How much the Mod Wheel controls the amount of Reverb effect. Use the upper Data knob to adjust this
parameter. Fully anticlockwise the Reverb will be reduced with full modulation of the Mod Wheel, fully clockwise the Reverb will be
increased with full modulation of the Mod Wheel. The range of this parameter is -64 to +63. This parameter is memorised with a
Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the
Part’s “Part FX” parameter.
Chorus/Flanger/Phaser Level - Knob
This knob adjusts the level of the Chorus/Flanger/Phaser effect to be assigned to the selected Program. Turning this knob fully
anticlockwise will allow the signal to be unaffected by the Chorus/Flanger/Phaser, turning this knob fully clockwise will fully imple-
ment the Chorus/Flanger/Phaser effect. The range of this parameter is 000 to 127. This parameter is memorised with a Program in
Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of the Part’s “Part FX”
parameter.
Menu - Button ( Chorus/Flanger/Phaser )
When this button is pressed a series of pages is available on the display containing parameters relevant to this section.
In the Chorus/Flanger/Phaser section there are 6 pages available. These are selected using the page Up & page Down buttons to
the left of the display. There are a maximum of 2 parameters displayed on any page. One for each line on the display. The upper &
lower Data knobs on the right of the display are used to alter these parameter’s values.
Reverb wheel +2O
Reverb decay O8O
Reverb HF damp O2O
EFFECTS SECTION
101
To Next Page
Loading...
