EFFECTS SECTION
Page 2 looks like so:
The higher parameter is “Pan depth” In this case with a value of 080.
This parameter controls the intensity of the Autopan & Tremolo effects. Use the upper Data knob to adjust this parameter. In the
000 position there is no movement of sound in the stereo field & no change to the programs volume. ( No Autopan or Tremolo
effects will be heard ) As the value of this parameter is increased the Autopan & Tremolo have more & more effect. The range is
000 to 127 Off. This parameter is memorised with a Program in Program Mode or memorised with a Program or Performance in
Performance Mode depending on the value of the Part’s “Part FX” parameter.
The lower parameter is “Dry level”. In this case with a value of 020.
This parameter determines how much “Dry” signal is in the mix. Use the lower Data knob to adjust this parameter. This allows “Pre”
effects “Sends” arrangements to be realised. If this parameter is set to 000 no “Dry” sound from the Program will be heard. The
sound you will hear will be 100% effect signals. i.e. If the Chorus “Send” is set to 127 & the “Dry level” parameter is set to 000 you
will hear only the “Chorused” signal, none of the original. The range of this parameter is 000 to 127. This parameter is memorised
with a Program in Program Mode or memorised with a Program or Performance in Performance Mode depending on the value of
the Part’s “Part FX” parameter.
EQ/Comb Filter/Special - Button
When this button is pressed a series of pages is available on the display containing parameters relevant to this section.
In the Special section there are 8 pages available.
There are a maximum of 2 parameters displayed on any page. One for each line on the display. The upper & lower Data knobs on
the right of the display are used to alter these parameter’s values.
Page 1 looks like so:
The higher parameter is “EQ treble”. In this case with a value of +00.
This parameter adjusts treble of the selected sound. Use the upper Data knob to adjust this parameter. The range of this parame-
ter is-64 to +63. This parameter is memorised with a Program in Program Mode or memorised with a Program or Performance in
Performance Mode depending on the value of the Part’s “Part FX” parameter.
The lower parameter is “EQ bass”. In this case with a value of +00.
This parameter adjusts bass of the selected sound. Use the lower Data knob to adjust this parameter. The range of this parameter
is-64 to +63. This parameter is memorised with a Program in Program Mode or memorised with a Program or Performance in
Performance Mode depending on the value of the Part’s “Part FX” parameter.
Page 2 looks like so:
The higher parameter is “Comb frequency”. In this case with a value of 069.
This parameter adjusts the Frequency range of the Comb Filter. Use the upper Data knob to adjust this parameter. The range of
this parameter is-64 to +63. This parameter is memorised with a Program in Program Mode or memorised with a Program or
Performance in Performance Mode depending on the value of the Part’s “Part FX” parameter.
Comb frequency O69
Comb boost +1O
EQ treble +OO
EQ bass +OO
Pan depth O8O
Dry level O2O
106
To Next Page
Loading...
