Novation Supernova II - Page 108

EFFECTS SECTION
Page 5 looks like so:
The higher parameter is “Comb freq wheel”. In this case with a value of +10.
This parameter adjusts the modulation of the Comb frequency from the Mod wheel. Use the higher Data knob to adjust this para-
meter. The range of this parameter is -64 to +63. This parameter is memorised with a Program in Program Mode or memorised
with a Program or Performance in Performance Mode depending on the value of the Part’s “Part FX” parameter.
The lower parameter is “Comb boost wheel”. In this case with a value of +10.
This parameter adjusts the modulation of the Comb boost from the Mod wheel. Use the lower Data knob to adjust this parameter.
The range of this parameter is -64 to +63. This parameter is memorised with a Program in Program Mode or memorised with a
Program or Performance in Performance Mode depending on the value of the Part’s “Part FX” parameter.
Page 6 looks like so:
The higher parameter is “Fx config”. In this case with a value of D+R+C.
This parameter changes the order/arrangement of the Delay, Reverb & Chorus/Flanger/Phaser effects. Different configurations can
make the effects sound quite different. i.e. a sound that is delayed then reverbed & then chorused sounds quite different to a sound
that has been Chorused then Delayed then Reverbed. There are 19 different effects configurations available in the Supernova II
Rack. Below is a diagram showing how the “Normal” effects configuration.
Below are diagrams showing how the different effects are connected in different configurations.
Delay
Rev
C/F/P
R > D > C
Delay
Rev
C/F/P
R > C > D
SERIES CONFIGURATIONS
Delay Rev C/F/P
D > R > C
Delay
Rev
C/F/P
D > C > R
Dist EQ Comb Pan
Delay
Rev
C/F/P
Input
Output
EFFECTS SECTION
IN THE NORMAL POSITION
( D + R + C )
The section enclosed
can be Morphed into
different configurations
Fx config D + R + C
Config morph OOO
Comb freq wheel +1O
Comb boost wheel +1O
108