PART EDIT SECTION
Polyphony - Button
This button works in Performance & Program mode.
This button alters the Polyphony of the currently selected Program or Part. When this button is pressed, the display shows parame-
ters relevant to this section. There are a maximum of 2 parameters displayed. One for each line on the display. The upper & lower
Data knobs on the right of the display are used to alter these parameter’s values.
When this button is pressed the display shows:
The higher parameter is “Part polyphony”. In this case with a value of Poly.
This parameter assigns how the much polyphony is assigned to the selected Part & is adjusted using the upper Data knob. If this is
set to Off ( Performance mode only ) the Part is disabled. No sound will come from this Part & it will not respond to MIDI. If this
parameter is set to Mono, only one voice is assigned to the Part. ( Monophonic ). If this is set to Poly, voices are dynamically allo-
cated to the Part. All voices will be dynamically shared by the Parts. If this parameter is set to Prog, the Polyphony setting of the
currently selected Program in the currently selected Part is mirrored by the Part. i.e. If a Monophonic Program was selected in the
Part then the Part’s polyphony would be Monophonic & if a Polyphonic sound was selected then the polyphony would automatically
change to Polyphonic. In Program mode, the display is different. It shows “Program Mode” on the top line of the display &
“Polyphony” on the bottom line.
When this button is pressed when in Program mode the display shows:
When in Program mode, the display is different but the function is the same. Use the lower Data knob to adjust this parameter. The
range of this parameter in the Performance mode is Off, Poly , Mono. & Prog. In the Program mode the range is Poly & Mono. This
parameter is memorised with Programs in Program Mode & Performances in Performance Mode.
Range - Button
This button only works in Performance mode.
This button alters the Key Range of the currently selected Part. When this button is pressed, the display shows parameters rele-
vant to this section. There are a maximum of 2 parameters displayed. One for each line on the display. The upper & lower Data
knobs on the right of the display are used to alter these parameter’s values.
When this button is pressed the display shows:
The higher parameter is “Highest note”. In this case with a value of C8.
This parameter selects the Highest note the currently selected Part will play on & is adjusted using the upper Data knob. The range
of this parameter is C-2 to G8 . This parameter is memorised with the Performance.
Highest note C8
Lowest note CO
Program mode
polyphony Mono
Part polyphony Poly
116
To Next Page
Loading...
