MULTITIMBRAL USE
The Part is Muted / No response at all - If the Part light flashes steadily, even with no MIDI input, the Part is Muted.
The Part is Muted / No response at all - Does the Part light flash when MIDI is sent?
- Yes - The Assigned outputs may be different to the ones connected, check the setting of the Outputs menu for the
offending Part.
- No - The MIDI Channel for the Part is set to the incorrect channel in the MIDI menu.
- No - Polyphony parameter in the Polyphony menu is set to “Off”.
The Part is in a different key to the others - The Part Semitone parameter in the Tune menu is not set to “0”
The Part is in a out of tune with the others - The Part Detune parameter in the Tune menu is not set to “0”
The sustain pedal behaves in reverse on the assigned Part - The Polarity of the pedal is set incorrectly, set the Sustain parameter
in MIDI menu to “Enable” or “Enable (I)” so that the desired effect is produced.
The Sustain pedal does not work on the assigned Part - The Sustain parameter in the MIDI menu is not set to “Enable” or “ Enable (i)”.
28
To Next Page
Loading...
