To assign no Program to a Part ( Off ) press set the Polyphony Parameter in the Polyphony button menu to “Off”.
Only one Performance can be used at any one time. Performances cannot be used as Parts of other Performances & you cannot
assign different Performances to different MIDI channels & expect to get Multiple Performances.
When Performance mode is entered, whatever Part happened to be selected when the Performance was saved is now selected.
To adjust the Program assigned to any Part, for example Part 1, press Part 1 button even if it is already lit. It will stay lit & the dis-
play will change from showing the Performance Bank, Number & Name to displaying the Part, Program, Number & name. To return
to the Performance Bank, Number & Name press the Performance button.
Writing Performances is a destructive operation. It is strongly advised to make back-ups of your data occasionally to a Computer,
Sequencer or Data filing device. Factory sounds in Performance banks A & B can be recalled from ROM see page 46 for details
Once a Performance has been created, you can store the Performance in any of the 512 Performances. To do so press the Write
button. The display shows:
The top line of the display shows the current Performance location & the Performance’s destination. The bottom line displays the
Performance’s name, in this case Blaster Master!
While in this mode, it is possible to change the destination of the new sound using the Bank & Keypad buttons. For example,
pressing 001 on the keypad in the above example & the display will show:
The destination of the Performance to be written is now A001.
While in this mode, the Compare button has a different function to its normal operation. The Compare button in this mode toggles
between the currently edited Performance & the destination Performance. The “Performance” button will flash when this function is active.
Once the destination for the Performance has been decided press the Write button again & the display shows:
The name of the Performance can be altered when in this mode. In the display the first character of the Performances name has a
cursor under it. Using the higher Data knob you can scroll through the character set for that character. Using the lower Data knob
you can move the cursor horizontally.
Name Perf AOO1
‘Blaster Master ‘
To Next Page
Loading...
