OSCILLATOR SECTION
Harden - Button
Mod Depth - Knob
ENV 2 - Button
This combination controls the modulation of the Harden Effect on the selected Oscillator by ENV 2. Turning the Mod Depth Knob fully
clockwise introduces Harden Effect from ENV 2 to the selected Oscillator in a Positive direction. Turning the Mod Depth Knob fully
anticlockwise introduces Harden Effect from ENV 2 to the selected Oscillator in a Negative direction. In the “Mid” position there is no
modulation at all. The range of this parameter is -64 to +63.
This does not apply to the 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources will be heard if an attempt
is made to adjust this parameter when these sound sources are selected & the display will show “Not Available”.
Harden - Button
Mod Depth - Knob
ENV 3 - Button
This combination controls the modulation of the Harden Effect on the selected Oscillator by ENV 3. Turning the Mod Depth Knob fully
clockwise introduces Harden Effect from ENV 3 to the selected Oscillator in a Positive direction. Turning the Mod Depth Knob fully
anticlockwise introduces Harden Effect from ENV 3 to the selected Oscillator in a Negative direction. In the “Mid” position there is no
modulation at all. The range of this parameter is -64 to +63.
This does not apply to the 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources will be heard if an attempt
is made to adjust this parameter when these sound sources are selected & the display will show “Not Available”.
Harden - Button
Mod Depth - Knob
Wheel - Button
This combination controls the modulation of the Harden Effect on on the selected Oscillator by the Mod Wheel. Turning the Mod
Depth Knob fully clockwise introduces Harden Effect from the Mod Wheel to the selected Oscillator in a Positive direction. Turning
the Mod Depth Knob fully anticlockwise introduces Harden Effect from the Mod Wheel to the selected Oscillator in a Negative
direction. In the “Mid” position there is no modulation at all. The range of this parameter is -64 to +63.
This does not apply to the 1*3 & 2*3 Ring Modulator outputs. No audible effect to these sound sources will be heard if an attempt
is made to adjust this parameter when these sound sources are selected & the display will show “Not Available”.
To Next Page
Loading...
