This section contains all the knobs & buttons associated with the Filter.
Menu - Button
When this button is pressed a series of pages is available on the display containing parameters relevant to this section.
In the Filter section there are 6 pages available. These are selected using the page Up & page Down buttons to the left of the dis-
play.
There are a maximum of 2 parameters displayed on any page. One for each line on the display. The upper & lower Data knobs on
the right of the display are used to alter these parameter’s values.
Page 1 looks like so:
The higher parameter is “Filter tracking”. In this case with a value of 000.
This parameter controls the amount of change to the Filter Cutoff Frequency ( initially set by the Frequency knob. ) by the pitch of
the note being played. Use the higher Data knob to adjust this parameter. Fully anticlockwise this parameter does not effect the
Cutoff Frequency of the filter if notes at different pitches are played. Clockwise from this position there will be an increasing amount
of modulation. i.e. The Filter will be opened more as higher notes are played on the master keyboard. This control is used to deter-
mine how the timbre of a sound changes over the master keyboard. At the fully clockwise position the Filter tracks the pitch
changes in a 1:1 ratio. The range of this parameter is 000 to 127. This parameter is memorised with a Program..
Page 2 looks like so:
The higher parameter is “Fq MWh LFO2 amt”. In this case with a value of +63.
This parameter determines how the Modulation Wheel affects the amount of Modulation of the Cutoff Frequency of the Filter from
LFO 2. This produces a Wah Wah type of effect. In the central position of the upper Data knob there is no change to the Filter
Cutoff Frequency when the Modulation Wheel is engaged. Anticlockwise of centre there will be an increasing amount of Negative
modulation. i.e. The Filter will be closed more by LFO 2 when the Modulation Wheel is engaged. Clockwise of centre the modula-
tion is Positive. i.e. The Filter will be increasingly opened by LFO 2 when the Modulation Wheel is engaged. The range of this para-
meter is -64 to +63. This parameter is memorised with a Program.
Fq Mwh LFO2 amt +63
Res Mwh LFO2 amt +63
Filter tracking OOO
To Next Page
Loading...
