FILTER SECTION
Possible Combinations & the effects Produced.
The range of all these parameters is -64 to +63. All these parameters are memorised with a Program.
Frequency Mod- Knob
LFO 1 - Button
This combination controls the amount of change to the Filter Cutoff Frequency ( Initially set by the Frequency knob ) by LFO 1.
With the Frequency Mod knob set to the central position there is no change to the Filter Cutoff Frequency. Anticlockwise of centre
there will be an increasing amount of Negative modulation. i.e. The Filter will be closed more by LFO 1. Clockwise of centre the
modulation is Positive. i.e. The Filter will be increasingly opened by LFO 1.
Frequency Mod- Knob
LFO 2 - Button
This combination controls the amount of change to the Filter Cutoff Frequency ( Initially set by the Frequency knob ) by LFO 2.
With the Frequency Mod knob set to the central position there is no change to the Filter Cutoff Frequency. Anticlockwise of centre
there will be an increasing amount of Negative modulation. i.e. The Filter will be closed more by LFO 2. Clockwise of centre the
modulation is Positive. i.e. The Filter will be increasingly opened by LFO 2.
Frequency Mod- Knob
ENV 2 - Button
This combination controls the amount of change to the Filter Cutoff Frequency ( Initially set by the Frequency knob ) by ENV 2.
With the Frequency Mod knob set to the central position there is no change to the Filter Cutoff Frequency. Anticlockwise of centre
there will be an increasing amount of Negative modulation. i.e. The Filter will be closed more by ENV 2. Clockwise of centre the
modulation is Positive. i.e. The Filter will be increasingly opened by ENV 2.
Frequency Mod- Knob
ENV 3 - Button
This combination controls the amount of change to the Filter Cutoff Frequency ( Initially set by the Frequency knob ) by ENV 3.
With the Frequency Mod knob set to the central position there is no change to the Filter Cutoff Frequency. Anticlockwise of centre
there will be an increasing amount of Negative modulation. i.e. The Filter will be closed more by ENV 3. Clockwise of centre the
modulation is Positive. i.e. The Filter will be increasingly opened by ENV 3.
Frequency Mod- Knob
Wheel - Button
This combination controls the amount of change to the Filter Cutoff Frequency ( Initially set by the Frequency knob ) by the Mod
Wheel. With the Frequency Mod knob set to the central position there is no change to the Filter Cutoff Frequency. Anticlockwise of
centre there will be an increasing amount of Negative modulation. i.e. The Filter will be closed more by the Mod Wheel. Clockwise
of centre the modulation is Positive. i.e. The Filter will be increasingly opened by the Mod Wheel.
Resonance/Width - Knob
LFO 1 - Button
This combination controls the amount of change to the Resonance ( Initially set by the Resonance knob ) by LFO 1. With the
Resonance Mod knob set to the central position there is no change to the Resonance. Anticlockwise of centre there will be an
increasing amount of Negative modulation. i.e. The Filter will become less resonant by LFO 1. Clockwise of centre the modulation
is Positive. i.e. The Filter will become more resonant by LFO 1.
When “Special” ( which are all Dual Filters ) Filter types are selected this parameter no longer modulates the Resonance of the
Filters but the spacing or “Width” between the 2 Filters Cutoff frequencies.
To Next Page
Loading...
