40
English
Creating a Beat Grid
ITCH will attempt to determine the rst transient (this could be a kick drum or bass note) and will
use this for the location of the Downbeat Marker.
to allow for tempo variations.
To check if the Beat Grid has calculated the markers correctly you can skip forwards through
the track to see if the markers fall on the beats or not (after a breakdown is a good place). It is
Setting a Beat Marker
Pressing the BEAT GRID SET button
46
will place a Beat Marker at the playhead position. By
default, ITCH places the Beat Marker on the closest detected transient.
NOTE: On the keyboard, pressing X, or holding ALT while double-clicking on the waveform
performs the same action.
TIP: Set new Beat Markers where there is a tempo change in the track to allow the tempo to warp
around these points.
To Next Page
Loading...