The Pulse Width Menu
The Pulse Width Menu allows the pulse width settings for the three oscillators to be set.
This increases/decreases the amount of time the waveform spends in a high or low state, to change
the sound of the waveform. The Pulse Width Menu is accessed by pressing the Menus/Audio button (so
that the lower LED lights) followed by the button above ‘pulse width’. Once in the Pulse Width Menu, use
the page up/down buttons next to the LCD screen to cycle through the following pages, using the data
encoder to change the settings for each page:
PW Osc1 Position – increases/decreases the pulse width of Oscillator 1
PW Osc1 Lfo2>PW – sets the amount that the pulse width of Oscillator 1 is modulated by LFO2
PW Osc1 ModEnv> – sets the amount that the pulse width of Oscillator 1 is modulated by the
Modulation Envelope
PW Osc2 Position – increases/decreases the pulse width of Oscillator 2
PW Osc2 Lfo2>PW – sets the amount that the pulse width of Oscillator 2 is modulated by LFO2
PW Osc2 ModEnv> – sets the amount that the pulse width of Oscillator 2 is modulated by the
Modulation Envelope
PW Osc3 Position – increases/decreases the pulse width of Oscillator 3
PW Osc3 Lfo2>PW – sets the amount that the pulse width of Oscillator 3 is modulated by LFO2
PW Osc3 ModEnv> – sets the amount that the pulse width of Oscillator 3 is modulated by the
Modulation Envelope
To Next Page
Loading...
