The Mixer Menu
The Mixer Menu contains the remaining controls for Oscillator levels and mixing. The menu is accessed
by pressing the Menus/Audio button (so that the lower LED lights) followed by the button above ‘mixer’.
Once in the Mixer Menu, use the page up/down buttons next to the LCD screen to cycle through the
following pages, using the data encoder to change the settings for each page:
MIX Output Level – sets the Level of the signal at the output of the Oscillators section
MIX Noise Level – sets the level of the Noise generator in the Oscillators section
MIX Ring12 Level – sets the amount of Ring Modulation between Oscillator 1 and 2. This multiplies the
two waveforms together to create a metallic (or bell-like) effect – the sound of the Daleks!
MIX Lfo1>Osc1 – sets the amount of modulation applied from LFO1 to Oscillator 1
MIX Lfo2>Osc1 – sets the amount of modulation applied from LFO2 to Oscillator 1
MIX Lfo2>Osc2 – sets the amount of modulation applied from LFO2 to Oscillator 2
MIX A/D Env>Osc3 – sets the amount of modulation applied from the AD Envelope to Oscillator 3
MIX Lfo1>Noise – sets the amount of modulation applied from LFO1 to the Noise Generator
Mix Lfo1>Ring12 – sets the amount of modulation applied from LFO1 to the Ring Modulator
MIX Noise Type – sets the Noise Type
WHITE – White Noise
HP – High-pass Noise
BP – Band-pass Noise
HP*BP – High-pass and band-pass (combined effect)
`
To Next Page
Loading...
