Restoring a Synth Patch
If a Synth patch has been edited on the Xio, the COMPARE buttons will flash to indicate that the sound has
changed. To listen to the saved preset, press and hold the COMPARE button. If the saved preset is preferred then
it can be restored simply by using the data encoder to scroll to another onboard sound and then to return to that
patch, e.g. if editing patch 256, then scroll to 255 then back to 256 to restore the saved settings. Make sure
that the Menus/Audio button has not been pressed if attempting to scroll to another sound, as the encoder is
used to edit Synth or Audio Menu pages when either of the LEDs above the button are lit.
Synth Levels
The level of the Synth has numerous controls, depending on the position in the signal path. In addition to the
overall level controls for the Heaphones and Line Outputs, there are separate controls to set the level of the Synth
across the analogue Outputs and over USB. These controls are knobs 6-9 (when in AUDIO/SYNTH mode):
To activate the parameters across the knobs, press and hold the Menus/Audio button so that the top LED lights;
pressing and releasing the button, so that the bottom LED lights, activates the Synth Menus mode so will not
suf
fice. Once in AUDIO/SYNTH mode, the knobs can be used to set the Main Level, that sent to USB (for
recording) and the stereo USB panning.
Main Synth Level Synth USB Level Synth USB panningPress and hold the Menus/Audio
button to activate Synth Levels mode
across knobs 7-9 (upper LED will light)
To Next Page
Loading...
