NOVOROL from
FOAM FILLED ROLLER DOOR WITH SURROUNDING BOX
(NOVOROL NR-20 CONTROL BOX WITH WIRED SAFETY EDGE)
STEP by STEP GUIDE
1 – Check Contents and condition of parts received
2 – Check Brickwork opening, dimensionally and condition
3 – Fit Guides to brickwork – Page 4
4 – Fit Box complete with Shaft – Page 4
5 – Fit Control Box to wall – Page 5
6 – Connect Motor via Test Leads and Mains – Page 5
7 – Run Shaft to BOTTOM Limit – Page 6
8 – Run Shaft to TOP Limit (Count Shaft Revs) – Page 6
9 – Run Shaft to Bottom Limit – Page 7
10 – Put Curtain over Shaft into Guides – Page 7
11– Connect Curtain to Shaft – Page 8
12 – Adjust BOTTOM Limit / Closed Position – Page 9
13 – Run Curtain to TOP – Page 9
14 – Adjust TOP Limit / Open Position – Page 9
15 – On Test Leads, Run Door to Fully Closed – Page 10
16 – ON Test Leads to Run, Run Door to Fully Open – Page 10
17 – Connect Motor and Safety Edge to Control Box – Page 10
18 – RUN Door via Control Box
19 – Program Handsets Page 10
20 – TEST Door (Safety Edge / Handsets) – Page 11
21 – Explain to End User how the door works
( 1 )
To Next Page
Need help?
General
