6
Phonix
User manual
GB
www.nowsonic.com
Operation
You can feed the high quality converters of your Nowsonic Phonix
either with the internal RIAA phono preamplifier or with an external
line source via the inputs on the rear panel. The INPUT button on the
front of Phonix toggles between the two sources.
NOTE: In the PHONO setting, the analog inputs are ltered with
an RIAA EQ especially for turntables. Please note that this equa
-
lizer curve is however not recommended for use with standard
line sour
ces.
The INPUT GAIN control on the front panel is used to set the gain
to the recording software. The two SIGNAL and CLIP LEDs are used
for metering: while the SIGNAL LED should light solid green when a
signal is present, the CLIP LED should only flash briefly at peak levels.
Please make sure to check the gain with the on screen meters of the
recording channel in your host software. To avoid any clipping of the
recording, lower the input level using the INPUT GAIN control.
Insert your headphones to the 1/8” TRS jack on the front panel: the
headphone level is adjusted via the MONITOR LEVEL control.
To Next Page
Loading...
Need help?
General
