Pressing the button creates a beeping sound. You’ll
see a green light when activated.
Try using it before ultrasonic mode because some
dogs can learn what happens if they don't stop
when you make this sound. If your dog stops after
the beep noise and starts to follow your commands,
remember to reward them for their good behavior.
Beep Mode Button - Use First
Press and hold the button. You’ll see a green light turn
on, which shuts o after 10 seconds. Release and
repress if needed.
Remember to start with the 25 kHz frequency and
rotate to the 20-30 kHz or 25 kHz so your dog does
not become immune to ultrasonic training methods.
Ultrasonic Mode Button - Use Second
Press the button once to turn on the CopBright torch.
Press again to activate SOS strobe mode. Press again
to shut o.
Torchlight & Strobe SOS Mode
Functions of Ultrasonic
To Next Page
Loading...