NSK EDD Megatorque Motor - Appendix 3: Backup and Restore Procedures; Using Handy Terminal FHT31 for Backup;Restore

Appendix
— A-10 —
Appendix 3: How to Back up and Restore the Settings of
Programs and Parameters
Backup and Restore is supported by using the handy terminal or EDD MegaTerm. Use appropriate means in accordance
with your environment.
Appendix 3-1: When Using the Handy Terminal FHT31
 The following describes how to back up the settings of parameters by the memory function of the Handy Terminal
FHT31.
 The Handy Terminal FHT11 cannot be used for the backup procedures described below. Refer to “Appendix 3.2.
Back up Manually”.
Preparation
 Handy Terminal FHT31, FHT21
How to back up
1) The parameter AO (Absolute position scale offset), which sets the Motor home position, and the parameter
MM (Multi-line monitor), which sets the monitoring mode to the Handy Terminal, won’t be backed up by
the following procedures.
Keep note by hand with the following procedures
(1) Monitor the setting of the parameter AO.
The setting of the parameter PO must be set to individual Motor, thus it shall be noted for each
Motor.
:?AO
AO123456
:_
A
?
ENT
O
(2) Monitor the setting of the parameter MM and note it.
AO123456
:?MM
MM1
:_
M
?
ENT
M
2) Back up the setting using the memory function of the Handy Terminal FHT31.
(1) While pressing the SHIFT key in the command waiting state, press the BS key for
approximately 3 seconds.
The mode changes from the normal node to the user mode and the menu will be on the display.
［Editor］ ?
1:Upload
2:Delete
3:Download
BS
SHIFT