Pour
one
quart
of
SAE
20
engine
oil into the oil tank.
Let
the
engine
idle
for
a few minutes
and
note
that
the oil
is
returned into the oil
tank
correctly. Then
drain
this oil
off
as
described
above
and
pour
in
one
quart
of
engine oil*.
Run
the
engine
until there
is
no further change
in
the
oil level, and then at
once
add
fresh oil to bring the
level up to that
of
the upper mark
on
the dipstick
- Do not overfill, Oil capacity 2
Htres
(3
1
/2
pints),
Every 1,200 miles
Control Levers on the Handlebars
should
be
lightly lubricated with
engine
oil.
Every 1,200 miles
Starter Spindle
Inject a few strokes
of
grease* into the nipple provided.
• See
page
68
Every 1,200 miles
Spindle for Foot-Brake Pedal
Inject a few strokes
of
grease* into the nipple provided.
Every
1,200 miles
Control Cables
After unhooking the
cables
allow some oil mixed with
petrol
to
trickle
down
between
the
inner
and
outer'
casings until it comes
out
at
the bottom.
In
order
to
,keep
out
water,
well
grease
the
upper
and
lower
ends
of
the
casings.
In
this connection, special attention
• should
be
devoted
to
the
clutch cable.
This work
is
simplified if a Bowden-cable lubricator,
which
is
obtainable
from accessory
dealers,
is
used.
• See
page
68
34
35
To Next Page
Loading...