Nu-Air Ventilation Systems Inc. - HRV Operating &Installation Manual
Rev October 10, 2010 - 20 -
7. MAINTENANCE
CAUTION: Disconnect power before servicing.
7.1. Filters:
Dirty filters can reduce ventilation efficiency, result in unbalanced airflow and damage or shorten the
life of the motors. Clean every three months. Polyester filters should be replaced annually. Permanent
electrostatic filters are available from your Nu-Air dealer. Filters remove easily by opening the front
cover.
7.2. Fans:
When cleaning the filters, take the opportunity to vacuum any interior surfaces including the fan blades.
No other service is required as these fans are designed to operate continuously without lubrication.
7.3. Condensate Drain:
Twice per year wipe clean the condensate drain pan. Check the condensate drain and tubing to ensure
they are free flowing. The tubing must have an "S" or loop that traps a quantity of water to prevent air
from entering the HRV via this tubing.
7.4. Core:
The core (located behind the cover) should be removed and cleaned at least once a year, using a mild
detergent in cold water (i.e. Arctic Power). To remove the cover of the machine, unlatch the two latches;
slide the door to right to release from hinges.
7.5. Exterior Hoods:
Regularly check the outside vents and clean any obstructions such as grass,
leaves or other debris. Do not replace the screen with mesh smaller than
1/4" as this will restrict airflow. During winter operation, ensure snow and
frost does not build up and restrict or block openings.
7.6. Grills & Duct Work:
Clean the grills when they are dusty or greasy with soap and water. Check
for punctures in the insulation jacket on the fresh air and exhaust air ducts.
Repair any punctures using foil tape.
8. ANNUAL SERVICING:
Your HRV should undergo annual general servicing by an accredited contractor. This servicing should
include the following:
a) The six maintenance items above.
b) A general check for proper operation. Controls and electrical connections should be inspected.
c) Verification that intake and exhaust air flows are properly balanced.
d) Re-balancing as necessary.
To Next Page
Loading...
