Nugsmasher Mini Operating Instructions
Thank you for the purchase of your Nugsmasher Mini. We have
designed this unit for the purpose of eortless rosin extraction for up to
3.5 grams of ower. When setting up your unit, please ensure your stand
is suitable for the weight of the machine. Also note that the unit gets
hot and the high temperature hydraulic heat plates are capable of bodily
injury if not used in a safe manner. (Please do not attempt to open your
unit casing as this will void your factory warranty.)
While our products are sturdy and built to last, they are also heavy and
shippers can be rough during handling. If there are any problems from
shipping and your item does not deliver safely please contact us direct
so we can resolve the matter immediately.
As always, please feel free to call us at any point with any questions or
concerns at 951-272-9800 or Contact@Nugsmasher.com.
Quick Start Guide:
When starting your unit make sure the plates are closed (surface of
plates should be pressed together) this will allow the temperature
sensor in the bottom plate to get an accurate top and bottom reading
and distribute the desired temperature to both plates.
Additionally, bring plates together for a minimum of 20 seconds
between presses if more than 5 minutes passes to ensure accurate
temperature readings.It is best to leave the plates together any time
the machine is on and not in use
.
20secs to 5mins
WARNING! Never turn your release knob more than ½ full turn counter clock wise from ght.
Turned too much!
Turned to the max!
Please Note: Your release knob is factory designed to be a slight upward
1
KEEP RELEASE VALVE IN CLOSED “CLOCKWISE POSITION” WHEN NOT IN USE
Please note that under any circumstances do not turn release valve more then ½ a turn in the open
( counter clockwise) direction as this will void your warranty and may result in hydraulic uid loss. Also make
sure when not in use or stored, the release valve must be in closed tight (clockwise) position.
To Next Page
Need help?
General
