NIBBLE 0x3 Assembly Instructions Rev03 10.22.20
THERE’S NO POWER
• Check that all LEDs are soldered in the proper orientation.
• Check the direction of the ICs.
• Check for other shorts – solder blobs, leads that were not clipped all the way, etc.
HOW TO I DO X IN FIRMWARE?
• See the QMK docs, or make a post on r/olkb for help.
• Send me a PM on Reddit or an email, and I’ll try to help.
SOMETHING ELSE?
• Visit nullbits.co/support/
• Reach out at help@nullbits.co
• Message u/jaygreco on Reddit
• Join our Discord!
To Previous Page
Loading...