Numark Mixtrack Quad Service Manual

14. FX Control – Adjusts the effect parameter in the software of the last activated effect. Hold Shift + FX
Control to select the effect.
15. Filter Adjust – Adjusts the amount of the filter. Turn the knob left to apply a low-pass filter and turn the
knob right to apply a high-pass filter.
16. Loop In – Press this pad to set the beginning of a loop when in Looping Mode. After a Loop Out point
is set, press this pad again to return the playback marker to the Loop In point.
Pressing Shift + Loop In will set the current Pad Mode as “Looping Mode”. See the Pad Mode
Commands section for information on this pad’s additional functions.
17. Loop Out – Press this pad to set the end of a loop when in Looping Mode. After a Loop Out point is
set, press this pad again to exit out of the loop. Pressing Shift + Loop Out will set the current pad
mode to “Sample (S)” Mode. See the Pad Mode Commands section for information on this pad’s
additional functions.
18. Reloop – Recalls the last set loop. When inside a loop, press this pad to turn the loop off. If a loop has
not been set, this button will create a loop from the start of the song or where Loop In was pressed.
Pressing Shift + Reloop will set the current pad mode to “Hot Cue Mode”. See the Pad Mode
Commands section for information on this pad’s additional functions.
19. Loop x1/2 – Press this pad to reduce the currently playing loop length by half when in Looping Mode. If
a loop is not playing, this will set the autoloop length. Press Shift + Loop 1/2 to double the loop length.
See the Pad Mode Commands section for information on this pad’s additional functions.
20. FX1 On/Off – Turns FX1 on and off per deck. When in Slip Mode this pad will perform a momentary
1/16 beat loop roll. Press Shift + FX1 to set and start playback of a 1-beat autoloop.
21. FX2 On/Off – Turns FX2 on and off per deck. When in Slip Mode this pad will perform a momentary
1/8 beat loop roll. Press Shift + FX2 to set and start playback of a 2-beat autoloop.
22. FX3 On/Off – Turns FX3 on and off per deck. When in Slip Mode this pad will perform a momentary
1/4 beat loop roll. Press Shift + FX3 to set and start playback of a 4-beat autoloop.
23. Filter Reset – Press this pad to reset the filter to the “0” position. When in Slip Mode this pad will
perform a momentary 1/2 loop roll. Press Shift + Filter Reset to set and start playback of a 16-beat
autoloop.
24. Channel Volume – Adjusts the volume of the individual channels in the software.
25. Master Volume – Adjusts the volume of the master mix coming from the software.
Note: This does not affect the microphone volume. Use the Mic Gain knob to control the microphone
volume.
26. Crossfader – Controls the blend between two decks.
27. High EQ – Controls the treble frequencies for the individual channels.
28. Mid EQ – Controls the mid-range frequencies for the individual channels.
29. Low EQ – Controls the bass frequencies for the individual channels.
30. Cue Gain – Adjusts the volume for headphone cueing in the software.
31. Cue Mix – Adjusts the software’s audio output to the headphones, mixing between the cue output and
the master mix output.
32. Stutter – Press this button while the music is playing to jump back to the last set cue point, creating a
"stutter" effect.
MIXER STANDARD
S/N : MORE THAN 96dB
HARMONIC DISTORTIONL : LESS THAN 0.03%

Numark Mixtrack Quad Specifications

General

Brand	Numark
Model	Mixtrack Quad
Category	DJ Equipment
Language	English