Nuna pipa lite rx User Manual

34 PIPA lite rx instructions 35PIPA lite rx instructions
PIPA RELX
™
Base Stability Leg
Refer to vehicle owner’s manual
to determine if stability leg can
be used. See page 38 for base
installation instructions.
1 - Press release button on bottom
of base to release the stability
leg from storage.
2 - Let the stability leg hang over
the edge of the vehicle seat.
After correctly installing the
base on the vehicle seat, press
the stability leg adjustment
button and extend the stability
leg perpendicular to the floor.
3 - Extend stability leg far enough
that it contacts the floor, the
stability leg indicator turns
green, and the leg locks into
position. Make sure the stability
leg is firmly planted on the floor
of the vehicle and does not easily
slide around.
4 - Indicators should show green,
meaning the stability leg is
properly contacting the floor.
If the stability leg indicator
shows red, the stability leg is
not making firm contact with
the vehicle floor. Adjust as
needed. Stability leg should be
perpendicular to the floor.
(continued on the next page)
1
2
3
4

Nuna pipa lite rx Specifications

General

Brand	Nuna
Model	pipa lite rx
Category	Baby Carrier
Language	English