MODEL • 112
®
Page 3
CHECK OPERATION
1. Turn thermostat counterclockwise to its lowest setting.
2. Turn on power to circuit at service entrance.
3. Turn thermostat clockwise. The heating element and fan should
come on. Set thermostat to desired temperature level. During
proper operation, the heater will cycle on and off periodically.
If heater does not come on:
1. Return the thermostat to lowest setting.
2. Shut off power at service entrance.
3. Remove the top cover. Check for proper line voltage and rein-
spect wiring connections. Reread installation procedure mak-
ing sure all steps were followed.
4. Also check the thermal fuse. It may be open and need to be
replaced. Consult the service parts list for the part number of a
replacement fuse. Follow the procedure described in the last
paragraph of the warranty when ordering replacement parts.
MAINTENANCE
NOTE: Always disconnect power at service entrance before clean-
ing or servicing heater.
The only maintenance required for this heater is to periodically
vacuum the front grille and housing. Simply remove the two side
angle support screws, slide heater out, and remove top cover for
access to the blower housing.
To Next Page
Loading...
Need help?
General
