12 13
This device complies with Industry Canada licence-exempt RSS standard(s) Operation
is subject to the following two conditions:
(1) This device may not cause interference, and
(2) This device must accept any interference, including interference that may cause
undesired operation of the device.
This equipment complies with IC radiation exposure limits set forth for an uncontrolled
environment. End user must follow the specific operating instructions for satisfying
RF exposure compliance. This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter.
These requirements set a SAR limit of 1.6 W/kg averaged over one gram of tissue.
The highest SAR value for this model phone when tested for use at the ear is 0.763W/
Kg and when worn on the body is 0.965W/Kg. The maximum scaled SAR in hotspot
mode is 1.260W/Kg.This device was tested for typical body-worn operations. To
comply with RF exposurerequirements, a minimum separation distance of 15mm
must be maintained between the user’s body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device should not
contain any metallic components. Body-worn accessories that do not meet these
requirements may not comply with RF exposure requirements and should be avoided.
Use only the supplied or an approved antenna.
Le présent appareil est conforme aux CNR d’Industrie Canada applicables aux
appareils radio exempts de licence.
Ce dispositif est conforme aux normes autoriser-exemptes du Canada RSS d’industrie
L’exploitation est autorisée aux deux conditions suivantes :
(1) l’appareil ne doit pas produire de brouillage, et
(2) l’utilisateur de l’appareil doit accepter tout brouillage radioélectrique subi, même
si le brouillage est susceptible d’en compromettre le fonctionnement.Cet équipement
est conforme avec l’exposition aux radiations IC définies pour un environnement
non contrôlé. L’utilisateur final doit respecter les instructions de fonctionnement
spécifiques pour satisfaire la conformité aux expositions RF. Cet émetteur ne doit pas
être co-localisées ou opérant en conjonction avec une autre antenne ou transmetteur.
Ces exigences définissent la valeur SAR limite à 1.6 W / kg en moyenne par gramme
de tissu. La valeur SAR la plus élevée pour ce modèle de téléphone testé à l’oreille
est 0.763W/Kg et lorsque porté sur le corps est 0.965W/Kg. l’échelle maximale sar
en mode hotspot est de 1.260W/Kg Cet appareil a été testé pour des opérations
portés sur le corps typiques. Pour se conformer aux exigences d’exposition aux
radiofréquences, une distance minimale de 15 mm doit être maintenue entre le
corps de l’utilisateur et le combiné, y compris l’antenne. Les pinces de ceinture, les
étuis et autres accessoires similaires utilisés par cet appareil ne doivent pas contenir
de composants métalliques. Les accessoires portatifs qui ne répondent pas à ces
exigences peuvent ne pas se conformer aux exigences d’exposition RF et doit être
évitée. Utilisez uniquement l’antenne fournie ou une antenne approuvée
IC Statement
Hearing-Aid Compatibility (HAC) Statement
The A10L(N5502L) has been tested for hearing aid compatibility. This device has an
M4 and T3 rating. When some wireless devices are used near some hearing devices
such as hearing aids and implants, users may detect abuzzing or humming noise.
Some hearing devices are more immune than others to this interference noise.Wireless
devices may also vary in the amount of interference they generate.
The ratings for compatibility of digital wireless devices with hearing aids are described
in the American National Standards Institute (ANSI) C63.19 standard:
M-Rating: Phones rated M3 or M4 meet FCC requirements and are likely to generate
less interference with hearing devices than phone that are not labeled. M4 is the
better/higher of the two ratings.
A10L( N5502L) is rated M4.
T-Rating: Phones rated T3 or T4 meet FCC requirements and are likely be more usable
with hearing devices’ telecoil than unrated phones. T4 is the better/higher of the two
ratings.
A10L(N5502L) is rated T3.
The more immune the hearing aid device is, the less likely one is to experience
interference noise from the wireless phone. Hearing aid devices may also be rated.
Adding the rating of the hearing aid and the phone would determine probable usability:
1. Any combined rating equal to or greater than six offers the best use.
2. Any combined rating equal to five is considered normal use.
The ratings are not guarantees. Results will vary depending on the user’s hearing
device and hearing loss. If your hearing device happens to be vulnerable to
interference, you may not be able to use this device successfully.Trying out this
device with your hearing device is the best way to evaluate it for your personal
needs.This device has been tested and rated for use with hearing aids for some of
the wireless technologies that it utilizes. However, there may be some newer wireless
technologies used in this phone that have not been tested yet for use with hearing
aids. It is important to try the different features of this phone thoroughly and in different
locations, using your hearing aid or cochlear implant, to determine if you hear any
interfering noise. Consult your service provider or the manufacturer of this phone for
information on hearing aid compatibility.
For information about hearing aids and digital wireless phones
FCC Hearing Aid Compatibility and Volume Control:
http://www.fcc.gov/cgb/dro/hearing.htm
To Next Page
Loading...
