Mute function
Mute
Working
Cabletone function
Auto-Off function
To Guitar
Mono Extension Cable
(1/4" Male-1/4" Female)
Transmitter
The IDs of the transmitter and the receiver of each B-5RC set have been
matched in the factory. For any reason you want to re-match IDs or pair
a receiver with a transmitter from different sets, follow these steps:
Turn off the transmitter and the receiver.
Press and hold their power buttons simultaneously for 8 seconds to
enter ID match status.
If it succeeds, the LEDs on both sides turn Green.
NUX offers various of 2.4GHz wireless systems, you can use up to 6
systems simultaneously in one space. Please avoid using other wireless
systems together with NUX one, or there may be noise or interference
issues.
The B-5RC power case can ONLY charge the NUX B-5RC. DO NOT plug
in any other wireless systems to the power case.
WARNING
Re-Match ID & Pairing Manually
If there is no signal for 10 minutes, the transmitter will turn off
automatically to save battery power. Since the transmitter turned off,
the receiver will turn off after 10 more minutes.
If you are using active
pickups, in order to reduce
noise, it is suggested to
k e e p m o r e d i s t a n c e
between the transmitter
and the internal circuits of
your guitar or bass.
Under working status, press the power button of the receiver to activate
the Cabletone function, and the LED of the receiver will turn Orange. The
Cabletone function simulates the capacitor effect of a 6.4m (21 feet) cable.
Tips for Active Pickups
You can also charge the wireless system using the included micro-b
USB Y cable. Please note that B-5RC can not work during the charging
process.
To recharge the power case, please make sure that your power adaptor
has an output of 5V and 1A(or above)
Under working status, press the power button
of the transmitter to mute the sound, and the
receiver LED will turn RED. Press again to have
sound again.
HowtoOperate
To Next Page
Loading...
Need help?
General
