04
INSTALLATION AND SETUP
12 Test your hardware setup.
This screen is used to
verify that your hardware
is properly configured to
view stereoscopic 3D
effects and that your
glasses and emitter are
functioning properly.
Follow the directions on
the screen.
13 (For LCD displays only)
Do you notice flicker in
your peripheral vision
when looking through
the glasses?
If you are seeing excessive
flicker in your peripheral
vision, this screen allows
you to change the refresh
rate of your display. When
you select Yes, the refresh
rate options are displayed.
Select the Test with this refresh rate button to verify that
your selection helps with the flicker.
If you cannot see the proper images, the Setup Wizard
will not continue until the hardware issue is resolved.
Use the Back button to check your glasses, emitter and
hardware configuration.
To Next Page
Loading...
Need help?
General
