7. Install the MOS-FET heatsink
(a) Remove protective tape on the bottom of the heatsink. Next, install the #4 heatsink as shown in the left photo
below. For Founders Edition cards (#A), hold the heatsink in place and turn the card over. Tighten 3 #13 screws, as
shown in the right photo below.
(b) If you have a Blower or iCX model (#B,#C,#D), please check to make sure that your thermal pads are in the same
location as the left photo below. If not, please check the back of the card in case the matching thermal pad remains
on the card. Install the heatsink, as shown in the left photo above. Hold the heatsink in place and turn the card over.
Place the left backplate over the card and tighten the backplate with 3 #6 screws, as shown in the right photo below.
8. For all cards, install #15 rubber insert onto the metal post and make sure the grooves are facing upwards.
To Next Page
Loading...
