EasyManua.ls Logo

NXP Semiconductors KL25 Series - Page 94

NXP Semiconductors KL25 Series
807 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
USB
Regulator
USB
XCVR
USB
Controller
USB0_DM
USB0_DP
VDD
VOUT33
VREGIN
TYPE A
D+
D-
VBUS
C
stab
To PMC and Pads
Chip
VSS
Charger
Li-Ion
Si2301
Figure 3-30. USB regulator Li-ion usecase
3.9.1.2.3 USB bus power supply
The chip can also be powered by the USB bus directly. In this case, VOUT33 is
connected to VDD. The USB regulator must be enabled by default to power the MCU,
then to power USB transceiver or external sensor.
USB
Regulator
USB
XCVR
USB
Controller
USB0_DP
USB0_DM
VDD
VOUT33
VREGIN
TYPE A
D+
D-
VBUS
Cstab
To PMC and Pads
Chip
Figure 3-31. USB regulator bus supply
3.9.1.3 USB power management
The regulator should be put into STANDBY mode whenever the chip is in Stop mode.
Communication interfaces
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
94 Freescale Semiconductor, Inc.

Table of Contents

Related product manuals