NXP Semiconductors Layerscape LS1028A BSP - Qci Test Cases

#The stream would got about half line rate
4.2.13.3.3 Qci test cases
Perform background setting as follows:
• Set eth0 MAC address:
ip link set eth0 address 10:00:80:00:00:00
Testcenter MAC address 99:aa:bb:cc:dd:ee as example
• SETUP 2 as hardware setup:
Figure 10. SETUP2
Test SFI No Streamhandle
Follow the following procedure to test no streamhandle for stream filter.
1. Set a close gate stream id 2, no stream identify package check and other streams will pass gate.
tsntool> qcisfiset --device eth0 --index 2 --gateid 2
Streams no streamhandle should pass this filter.
tsntool> qcisfiget --device eth0 --index 2
2. Send one frame from Test center.
tsntool> qcisfiget --device eth0 --index 2
3. Set Stream Gate entry 2.
tsntool> qcisgiset --device eth0 --index 2 --initgate 1
4. Send one frame from Test center.
tsntool> qcisfiget --device eth0 --index 2
5. Set Stream Gate entry 2, gate close permanently.
tsntool> qcisgiset --device eth0 --index 2 --initgate 0
Linux kernel
Layerscape LS1028A BSP User Guide, Rev. 0.3, 04/2019
114
NXP Semiconductors