NXP Semiconductors MKL25Z128VLK4 - Flash Protection

27.4.1 Flash Protection
Individual regions within the flash memory can be protected from program and erase
operations. Protection is controlled by the following registers:
• FPROTn — Four registers that protect 32 regions of the program flash memory as
shown in the following figure
Program flash size / 32
Program flash size / 32
Program flash size / 32
Program flash size / 32
Program flash size / 32
Program flash size / 32
Program flash size / 32
FPROT3[PROT0]
0x0_0000
FPROT3[PROT1]
FPROT3[PROT2]
FPROT3[PROT3]
FPROT0[PROT29]
FPROT0[PROT31]
FPROT0[PROT30]
Program flash
Last program flash address
Figure 27-24. Program flash protection
27.4.2 Interrupts
The flash memory module can generate interrupt requests to the MCU upon the
occurrence of various flash events. These interrupt events and their associated status and
control bits are shown in the following table.
Table 27-24. Flash Interrupt Sources
Flash Event Readable
Status Bit
Interrupt
Enable Bit
Flash Command Complete FSTAT[CCIF] FCNFG[CCIE]
Flash Read Collision Error FSTAT[RDCOLERR] FCNFG[RDCOLLIE]
Chapter 27 Flash Memory Module (FTFA)
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
Freescale Semiconductor, Inc. 433