38.4.1.9 Clock stretching
The clock synchronization mechanism can be used by slaves to slow down the bit rate of
a transfer. After the master drives SCL low, a slave can drive SCL low for the required
period and then release it. If the slave's SCL low period is greater than the master's SCL
low period, the resulting SCL bus signal's low period is stretched. In other words, the
SCL bus signal's low period is increased to be the same length as the slave's SCL low
period.
38.4.1.10 I2C divider and hold values
NOTE
For some cases on some devices, the SCL divider value may
vary by +/-2 or +/-4 when ICR’s value ranges from 00h to 0Fh.
These potentially varying SCL divider values are highlighted in
the following table. For the actual SCL divider values for your
device, see the chip-specific details about the I2C module.
Table 38-41. I2C divider and hold values
ICR
(hex)
SCL
divider
SDA hold
value
SCL hold
(start)
value
SCL hold
(stop)
value
ICR
(hex)
SCL
divider
(clocks)
SDA hold
(clocks)
SCL hold
(start)
value
SCL hold
(stop)
value
00 20 7 6 11 20 160 17 78 81
01 22 7 7 12 21 192 17 94 97
02 24 8 8 13 22 224 33 110 113
03 26 8 9 14 23 256 33 126 129
04 28 9 10 15 24 288 49 142 145
05 30 9 11 16 25 320 49 158 161
06 34 10 13 18 26 384 65 190 193
07 40 10 16 21 27 480 65 238 241
08 28 7 10 15 28 320 33 158 161
09 32 7 12 17 29 384 33 190 193
0A 36 9 14 19 2A 448 65 222 225
0B 40 9 16 21 2B 512 65 254 257
0C 44 11 18 23 2C 576 97 286 289
0D 48 11 20 25 2D 640 97 318 321
0E 56 13 24 29 2E 768 129 382 385
0F 68 13 30 35 2F 960 129 478 481
10 48 9 18 25 30 640 65 318 321
11 56 9 22 29 31 768 65 382 385
12 64 13 26 33 32 896 129 446 449
13 72 13 30 37 33 1024 129 510 513
Table continues on the next page...
Functional description
KL25 Sub-Family Reference Manual, Rev. 3, September 2012
706 Freescale Semiconductor, Inc.
To Next Page
Loading...
