Signal Description
MPC5606S Microcontroller Reference Manual, Rev. 7
Freescale Semiconductor 109
EVTI Nexus Nexus2+ event input trigger.
EVTO Nexus Nexus2+ event output trigger.
MCKO Nexus Output clock for the development tool.
MDO[0:3] Nexus Message output port pins that send information bits to the
development tools for messages such as Branch Trace Message
(BTM), Ownership Trace Message (OTM), Data Trace Message
(DTM). Only available in reduced port mode.
MSEO Nexus Output pin—Indicates the start or end of the variable length message
on the MDO pins.
PDI[0:17] DCU (PDI) Video/graphic data in various RGB modes input to the DCU.
PDI_DE DCU (PDI) Input signal indicates the validity of pixel data on the Input PDI data
bus.
PDI_HSYNC DCU (PDI) Input indicates the timing reference for the start of each frame line for
the PDI Input data.
PDI_PCLK DCU (PDI) Input pixel clock from PDI.
PDI_VSYNC DCU (PDI) Input indicates the timing reference for the start of a frame for the PDI
input data.
RXD_0 LINFlex SCI/LIN Receive data signal—This port is used to download the code
for the BAM boot sequence.
RXD_1 LINFlex SCI/LIN Receive data signal. Input pad for the LIN SCI module.
Connects to the internal LIN second port.
TXD_0 LINFlex SCI/LIN Transmit data signal. This port is used to download the code
for the BAM boot sequence.
TXD_1 LINFlex SCI/LIN Transmit data signal—Transmit (output) port for the second
LIN module in the chip.
SOUND SGL Sound signal to the speaker/buzzer.
SSD[0:5]_0
SSD[0:5]_1
SSD[0:5]_2
SSD[0:5]_3
SSD Bidirectional control of stepper motors using stall detection module.
M[0:5]C0M
M[0:5]C0P
M[0:5]C1M
M[0:5]C1P
SMC Controls stepper motors in various configurations.
CLKOUT MC_CGM Output clock—It can be selected from several internal clocks of the
device from the clock generation module.
Table 3-6. Signal details (continued)
Signal Peripheral Description
To Next Page
Loading...
