NXP Semiconductors MPC5777M - Page 164

MPC5777M Microcontroller Data Sheet, Rev. 6
Document revision history
NXP Semiconductors164
4 9/2014
Electrical characteristics—Device voltage monitoring electrical characteristics
• In Table 37 (Voltage monitor electrical characteristics), revised the entries for V
LVD108
and V
LVD145
.
Electrical characteristics—Flash memory electrical characteristics
• Multiple changes throughout Section 3.15, Flash memory electrical characteristics.
Electrical characteristics—AC specifications—GPIO delay
•In Table 72, changed parameter to “Delay from SIUL2 MSCR register bit update to pad
function enable at the input of the I/O pad” (was “Delay from MSCR bit update to pad
function enable”).
Electrical characteristics—Thermal Characteristics
• Updated Table 74 (Thermal characteristics).
Ordering Information
• Revised Table 75 (Orderable part number summary).
5 6/2015
Electrical characteristics—Absolute maximum ratings
Table 6 (Absolute maximum ratings)
•V
DD_LV_BD
: corrected footnote numbering.
• Revised footnote (“Allowed 1.38– 1.45 V...”) text to 1.38 (was 1.375). Revised footnote
(“1.32 – 1.38 V range...”) text to 1.38 (was 1.375) and “1.326 V at maximum” (was
“1.288 V at maximum”).
Electrical characteristics—Operating conditions
Table 8 (Device operating conditions)
• Consolidated duplicate footnotes throughout table.
•V
DD_HV_ADV
: added footnote (“SAR ADC only...”) to LVD disabled conditions.
• Revised V
DD_HV_ADR_D
row.
• Changed V
RAMP_LV
max value to 100 V/mx (was 500).
• Revised footnote (“RAM data retention is guaranteed at a voltage...”) (was “RAM data
retention is not guaranteed below...”).
Table 9 (Emulation (buddy) device operating conditions)
• Changed V
RAMP_LV_BD
max value to 100 V/ms (was 500).
Electrical characteristics—DC electrical specification
Table 10 (DC electrical specifications)
•I
DD_MAIN_CORE_AC
: changed max value to 115 mA (was 105).
•I
DD_CHKR_CORE_AC
: changed max value to 80 mA (was 45).
•I
DDSTBY_REG
: changed max value to 50 µA (was 30).
•V
STBY_BO
specification: changed minimum to no value (was 0.9 V) and maximum to
0.9 V (was no value) with footnote (“V
STBY_BO
is the maximum voltage...”).
•V
DD_LV_STBY_SW
: changed min value to 0.93 V (was 0.95).
Electrical characteristics—Reset pad (PORST, ESR0) electrical characteristics
Table 20 (Reset electrical characteristics)
• Changed V
IH
min value to 2.2 V (was 2.0).
• Changed W
FNMI
max value to 15 ns (was 20).
Table 76. Revision history (continued)
Revision Date Description of changes