NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 16 / 45
1. After reboot with SW200 shorted.
Figure 15. LPC 1769 as USB device (from default LPC FW)
The LPC on the PNEV5180 will automatically reboot and then the PNEV5180B is ready
to be used with the NFC Cockpit.
3.2.4 Re-installing LPC FW after IDE use
The LPC1769 might be used for software development together with one of the samples
(including the NFC Reader Library, see [7]). In such case the LPC FW must be re-
installed afterwards, if the PNEV5180B is supposed to be used together with the NFC
Cockpit again. Reason for this is that any software development using the LPCXpresso
will erase the default firmware.
Therefore, the LPC FW needs to be re-flashed:
c:\nxp\NxpNfcCockpit_v<VERSION>\firmware
\Secondary_PN5180\BootLoader_And_Nfcrdlib_SimplifiedAPI_EMVCo_Secondary.bin
Binary file that has already stacked Boot loader from address 0x0000 onwards and
Upper Secondary Application at address 0x4000. So, this file can be used to flash on
LPC1769 as a single binary from address 0x0000 onwards using relevant Debuggers/
Flash Programmers.
In any case the correct PC driver must be installed, before the NFC Cockpit can be used
with the PNEV5180B 2.0 evaluation board.
To Next Page
Loading...