NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 20 / 45
Writes a single byte into EEPROM using byte address from 0x00 to 0xFC
Store and restore the complete EEPROM
• Dump EEPROM
Stores the complete “user area” of the PN5180 EEPROM into a XML file. This can be
used to generate a backup of all settings or to transfer optimized settings onto another
board or into own software. This includes the RF_CONFIG area.
• Load EEPROM
Load a XML file and stores the content into the user area of the PN5180 EEPROM. The
format is fixed and must fit.
1. EEPROM means User area of the EEPROM, details refer to [1]
Figure 19. PN5180 direct EEPROM access
4.4 PN5180 Dynamic Power Control
The DPC tab provides the functionality to easily perform a correlation test, a DPC
calibration and the DPC trimming (see Fig 20). The detailed functionality is described in
[4], but also the video tutorials might be a good help (refer to [8]).
To Next Page
Loading...