NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 22 / 45
the NFC cockpit tries to overrule that in the AWC tab. Disabling the AWC changes the
EEPROM.
Note: It is recommended to store the complete EEPROM content (backup!) using the
<Dump EEPROM> before disabling the AWC. This allows an easy recovery at any time,
even if the EEPROM is messed up.
1. Example: Running in an endless loop for Type A @ 106 settings
Figure 21. PN5180 AWC
4.5.1 Proposal for “static” Tx shaping adjustment
Step1: Save EEPROM for backup (<Dump EEPROM>), then disable the AWC (<Disable
AWC>).
To Next Page
Loading...