NXP Semiconductors PN5180 - 4.7.3.1 Input parameters; 4.7.3.2 Permutation settings

NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 27 / 45
Refer also to 6 for one example for type A without AWG and one example for type B with
AWG.
Such an XML file defines all test parameters. The user can create (copy & paste) own
XML files, chose any from the existing XML files and then start the test.
4.7.3.1 Input parameters
Table 1. Test input
Parameter Meaning Example value
numberMaxOfPasses How many trials per combination 10
skipAfterFailures Continue with the next combination if more failures
occur than defined
4
delayMS Additional delay between trials, if needed 0
fieldReset Enable RF Reset, if needed (e.g. for type A card) YES
protocolType Defines the used protocol and bit rate RM_A_106
Table 2. Send Data input
Parameter Meaning Example value
shortFrame Enables a short frame (e.g. for REQA) YES
rxCRC Enables the CRC check for the card response NO
txCRC Enables the CRC on the TX data NO
timeOutInUs Defines the time out of the test command in µs 1000
Byte(s) to be sent These bytes are sent. 0x26
Table 3. Read Data input
Parameter Meaning Example value
invertedMaskBytes Allows to mask certain bytes (for e.g. the PUPI) in the
card response
0x00, 0x00
Bytes to be received These bytes are checked as Rx data 0x44, 0x03
Optional, if AWG is connected:
<VoltageLevel minValueInmV="100" maxValueInmV="2000" stepSizeInmV="500"/>
Defines the LMA voltage level of the AWG from minimum to maximum value with given
step size.
4.7.3.2 Permutation settings
For the permutation test the registers and fields must be defined. The RxMatrix test
needs to know the register (by name or address), the field, which has to be permutated
(by field name or bit position and length), and it has to know the range or values, which
shall be used for the permutation.
For the register and field definition in the input file, two options are available: