EasyManua.ls Logo

NXP Semiconductors PN5180 - 4.8.2 AWG setup and test for type A @ 106

NXP Semiconductors PN5180
46 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 29 / 45
Remark: This NI VISA version does not conflict with the CTC Advanced WavePlayer tool.
Make sure that the .NET development support is installed, as shown in Fig 25.
1. Install the .NET (IVI) development support!
Figure 25. NI VISA installation
4.8.2 AWG setup and test for type A @ 106
The Fig 26 shows a typical setup for a type A response. After connecting the AWG the
type A protocol with 106 kbit/s can be chosen. The sample rate defines the number of
samples per half of a subcarrier cycle.

Other manuals for NXP Semiconductors PN5180