NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 41 / 45
7.1 LPC ABEND Driver installation (if needed)
Note: this section is not needed anymore, if the LPC FW update is done a described in
3.2.3.
At first connection of the PNEV5180B (with default firmware) to the PC, the device asks
for a driver. The driver must be chosen from
c:\nxp\NxpNfcCockpit_v<VERSION>\AbendPCDrivers\\PC_SW
\LPCBOARD_DRIVER_WIN
After successful installation of the driver, the device must be registered as two
LIBUSB_WIN32 devices (one for each SPI line), as shown in Fig 33.
If only one device is registered, either old drivers have been chosen or an older version
of lpc_main.bin is used.
Note for possible future NFC Cockpit updates: Please make sure to use latest driver
version, otherwise the application might not work correctly. In case of doubt re-install the
driver of the corresponding NFC Cockpit package.
1. Two LPCBOARD-USB devices must show up.
Figure 33. LPC driver
To Next Page
Loading...