NXP Semiconductors
AN11744
PN5180 Evaluation board quick start guide
AN11744 All information provided in this document is subject to legal disclaimers. © NXP B.V. 2018. All rights reserved.
Application note Rev. 1.3 — 2 February 2018
COMPANY PUBLIC 371213 7 / 45
JTAG Interface
Serial EEPROM not assembled
Figure 4. JTAG interface and Serial EEPROM
2.2.2 Power supply
The default settings use the power supply from the USB connector. For the maximum
performance and a better test capability the external power supply should be connected.
The AC or DC power input can cover any power supply providing an AC or DC voltage
between 7.5 and 12V.
To Next Page
Loading...