PN7462 family Quick Start Guide - Development Kit
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2018. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.6 — 14 May 2018
319816
7.5.2 Contact component view
In the Fig 53 contact component view for the “phExMain” example is shown.
Fig 53. Contact architecture view
7.6 Building a project from bottom to top
In order to use the PN7462 family firmware, a stack of components has to be initialized
from bottom to top. Every component in the software stack has to be initialized before it
can be used. The referred initialization of each layer generates a data context which
feeds the immediate upper layer. Some of the components may need a data context
coming from the same layer to be used as an entry point.
The Fig 54 illustrates the mentioned implementation for the initialization procedure of a
“phExtMain” application.
Fig 54. Project initialization order
To Next Page
Loading...
