PN7462 family Quick Start Guide - Development Kit
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2018. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.6 — 14 May 2018
319816
9.4 PN7462AU_ex_phExRf (CL functionality)
The “phExRf” is an example which implements the polling for contactless cards without
NFC Reader Library support. Application use only HAL APIs and perform same CLIF
functionality as 0 “phExMain” example with the only difference that for the transaction
static predefined packets are used.
Application does not implement CT and “Standby” functionality and it is not based on the
FreeRTOS.
9.4.1 Demo setup
This section describes in detail the setup and execution environment required for
“phExRf” application.
The following devices are required to run the example:
1. PNEV7462B/C board
2. LPC-Link2 board
3. Power adapter
4. Contactless cards Type A, Type B, Type F, ISO15693
5. NFC Enabled Phone
External p ower
sup ply
LPC -LIN K2
Fig 88. HW setup for the “phExRF”example
9.4.2 Features
“phExRF” example is covering next features:
Table 12. “phExRf” Example features
To Next Page
Loading...
