NXP Semiconductors PN7462AU - Pn7462 Au_Ex_Phexctemvco (CT Functionality); Demo Setup; Features; Emvco Activation

NXP Semiconductors
UM10883
PN7462 family Quick Start Guide - Development Kit
UM10883
All information provided in this document is subject to legal disclaimers.
© NXP B.V. 2018. All rights reserved.
User manual
COMPANY PUBLIC
Rev. 1.6 — 14 May 2018
319816
96 of 120
9.7 PN7462AU_ex_phExCTEMVCo (CT functionality)
The “phExCtEMVCo” is an example which implements the CT functionality with CT Pal
library support. Application use CT PAL library APIs and perform same CT functionality
as 0 “phExEMVCo” example with the only difference that for the transaction static
predefined packets are used. After the transactions, deactivation is performed. The
example is also capable of determining the Non-EMVCo card.
Application does not implement CLIF and “Standby” functionality and it is not based on
the FreeRTOS.
9.7.1 Demo setup
In this example, the same setup is used as in “phExEMVCo” example.
9.7.2 Features
“phExCT” example is covering next features:
Table 14. “phExRf” Example features
Feature
supported
CLIF Interface
No
CT Interface
Yes
NXP NFC Reader Library
No
CT Pal Library
Yes
FreeRTOS
No
Non RTOS
Yes
Standby mode
No
HIF/MIF Interface
No
9.7.3 EMVCo activation
The example performs an EMVCo activation and EMVCo ATR parsing. It also
determines the protocol supported by the card and applies the protocol supported.
9.7.4 APDU transactions
The example is capable of sending select commands for nine pre-selected types of
EMVCO cards after successful activation.
1. Master Card: Credit or Debit
2. Visa Card: Credit or Debit
3. Master Card: Maestro (debit card)
4. Master Card: Cirrus (inter-bank network)
5. Master Card: Maestro UK
6. Visa Card: Electron card
7. Visa Card: V PAY card
8. Visa Card: VISA Plus card
9. Amex Card