Table 4-2. Image layout in NOR flash
Start address End address Image Max size
0xEFF40000 0xEFFFFFFF U-Boot (current bank) 768KB
0xEFF20000 0xEFF3FFFF U-Boot env (current bank) 128KB
0xEFF10000 0XEFF1FFFF QUICC Engine microcode (current bank) 64KB
0xEFF00000 0xEFF0FFFF FMan microcode (current bank) 64KB
0xED300000 0xEFEFFFFF rootfs (alternative bank) 43MB
0xEC800000 0xEC8FFFFF Hardware device tree (alternative bank) 1MB
0xEC020000 0XEC7FFFFF Linux.uImage (alternative bank) 7MB+875KB
0xEC000000 0XEC01FFFF RCW (alternative bank) 7MB+875KB
0xEBF40000 0XEBFFFFFF U-Boot (alternative bank) 768KB
0xEBF20000 0XEBF3FFFF U-Boot env (alternative bank) 128KB
0xEBF10000 0XEBF1FFFF QUICC Engine microcode (alt bank) 64KB
0XEBF00000 0XEBF0FFFF FMan microcode (alternative bank) 64KB
0xE9300000 0XEBEFFFFF rootfs (current bank) 43MB
0XE8800000 0XE88FFFFF Hardware device tree (current bank) 1MB
0xE8020000 0xE86FFFFF Linux.uImage (current bank) 7MB+875KB
0xE8000000 0xE801FFFF RCW (current bank) 128KB
4.4 Switch settings
This chapter defines the default switch settings and other boot source settings.
NOTE
You may find slightly different default switch settings,
depending on the SDK being used; check the relevant
information.
4.4.1 Switch default settings (NOR flash boot)
This section defines the default switch settings for NOR flash boot.
NOTE
ON and OFF are being represented as 0 and 1 respectively, on
the board.
Switch settings
QorIQ T1040 Reference Design Board User Guide, Rev. 0, 06/2015
58 Freescale Semiconductor, Inc.
To Next Page
Loading...
